T-104Communications — Fiber Optic
Fiber Optic
FTTH, FTTP, and FTTD — inside plant to the subscriber drop.
Fiber carries more, further, and is immune to the electrical noise that copper picks up in a building full of motors and elevators. We handle it end to end: inside plant, riser, horizontal, and the terminations at both ends, with an OTDR trace to prove the run.
AWhat the install covers
- Single-mode and multi-mode design for the distance and bandwidth required
- Inside plant, riser, and horizontal fiber installation
- Fusion splicing and termination
- OTDR testing with results documented per strand
- Armoured and indoor/outdoor runs where the path demands it
O&MAfter handover
What we keep doing once it works.
Included in a management agreement. Without one, this is the part that quietly stops happening the day the installer drives away.
How managed service works →- Fault location and repair on damaged runs
- Strand records maintained as capacity is used
- Capacity planning ahead of bandwidth increases
QCommon questions
Fiber Optic, asked and answered.
- When does fiber make sense over copper?
- Over distance, between buildings or floors, where bandwidth needs headroom, and anywhere electrical noise is a problem. Copper is limited to roughly 100 metres per run; fiber is not, and it is immune to the interference that motors and elevators generate.
- What is the difference between single-mode and multi-mode?
- Single-mode carries further with less loss and suits campus and inter-building runs. Multi-mode is cheaper over short distances and is common within a building. The distance decides it.
- What are FTTH, FTTP, and FTTD?
- Fiber to the home, to the premises, and to the desk — how far the fiber is taken before it converts to copper. Taking it further costs more up front and leaves more headroom later.
- Do you test fiber after installation?
- Yes, with OTDR testing documented per strand. That gives a baseline trace, so if a run degrades later it can be compared against how it performed on day one and the fault located rather than guessed at.
T-900Next step
Every job starts with someone walking the building.
A site survey costs you nothing and produces a real drawing — device counts, cable paths, and a fixed number. Not a brochure.